Zenler Player
Your course is loading. Hang tight.
NREL Phase VI Wind Turbine CAD modeling in SOLIDWORKS 2020
Back to curriculum
0% Complete
0% Complete
Introduction to course
S809 airfoil coordinates
Understating flow and geometry angles in horizonal axis wind turbine (HAWT)
Importing S809 coordinates into Solidworks 2020
Creating plan 0 and sketch 0 for making airfoil from coordinates of S809
Creating point at 30% chord length for defining rotation axis
Creating square trailing edge
Creating 21 plans at given radial locations for the blade section
Creating 21 airfoils on 21 plans with given twist angle and chord length
Creating blade section from 21 section using Loft command in Solidworks
Creating transition and base support for NREL Phase VI wind turbine blade
Introduction
Introduction to course
Preview
Geometry modeling of NREL Phase VI turbine in Solidworks
S809 airfoil coordinates
Understating flow and geometry angles in horizonal axis wind turbine (HAWT)
Importing S809 coordinates into Solidworks 2020
Creating plan 0 and sketch 0 for making airfoil from coordinates of S809
Creating point at 30% chord length for defining rotation axis
Creating square trailing edge
Creating 21 plans at given radial locations for the blade section
Creating 21 airfoils on 21 plans with given twist angle and chord length
Creating blade section from 21 section using Loft command in Solidworks
Creating transition and base support for NREL Phase VI wind turbine blade
×
This is an unpublished lesson. This lesson will not be shown for students unless you set it as Public.
Back to Dashboard
No contents are available in this lesson!
No lessons available !
Back to Dashboard
Lesson contents locked
Enroll to unlock this lesson.
Enroll to unlock
Next Lesson